ELPRO 805U-E Bedienungsanleitung PDF herunterladen (Seite 54)

805U-E Wireless Ethernet User Manual

Man_805U-E Rev 1.5 Page 54

Client 1 Configuration

Perform the same configuration steps as the Access Point configuration with the following

differences:

• set IP address of 805U-E to 192.168.0.201

• set the Operating Mode to Client.

Ensure the same System Generator String is used and the same Radio Encryption method is

selected.

Client 2 Configuration

• As above, but use IP address 192.168.0.202

Alternate procedure – Adjust 805U-E network settings using serial

port(assuming configuration PC is on existing network)

a) Open terminal program with settings with data rate 19200bps, 8 data bits,

1 stop bit and no parity.

b) Set dipswitch to SETUP

c) Connect straight through serial cable to 805U-E and power up unit.

d) When prompted, strike the Enter key to abort automatic boot

e) Set IP address of 805U-E to 192.168.0.200 with command bip

192.168.0.200

f) Set netmask of 805U-E to 192.168.0.200 with command bnm

255.255.255.0

g) Set gateway address of 805U-E to 192.168.0.1 with command /jointfilesconvert/286502/bgw

192.168.0.1

h) Set dipswitch to RUN

i) Reset 805U-E with reset command.

j) Open configuration webpage with Internet Explorer at address

http://192.168.0.200/

When prompted for password, enter default username “user” and password

“user”

Enter “Quick Start”, and select Access Point.

IP address should be 192.168.0.200

Enter a System Generator String

Select the Radio Encryption required.

Save the changes.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 79 80

Keine Kommentare

ELPRO 805U-E Bedienungsanleitung Seite 54