ELPRO Libero Cx Betriebsanleitung PDF herunterladen (Seite 15)

EN - 15

liberoCONFIG

LI6003E

CONFIGURATION OF A LIBERO CX

3.2.5 Configuration mode

The configuration mode is used to set or change all logging features (profile).

liberoCONFIG is used for these settings.

Configuration is only possible if "ConF", "Strt" or the Profile-ID is displayed.

 3.4.2 Logging

 3.4.3 Alarm conditions

Display: New LIBERO

Unconfigured LIBERO Cx show "ConF" on the display.

Display: Configured

LIBERO Cx

Either "Strt" or the Profile-ID is shown on a configured but not started LIBERO Cx.

Start configuration

As soon as the LIBERO Cx is connected to the USB port, it switches to configuration mode.

 Continue with 3.4 Configuring the LIBERO Cx

Configuration com-

pleted

After configuration remove the LIBERO Cx from the USB port.

Either "Strt" or the Profile-ID is shown on the display.

Communication

error

THE FOLLOWING CASES COULD CAUSE COMMUNICATION PROBLEMS:

• Bad USB extension cable

• Passive USB hub. Please use an active USB hub or connect the LIBERO

Cx directly to the PC.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 63 64

Keine Kommentare

ELPRO Libero Cx Betriebsanleitung Seite 15