805U Radio Modem Module User Manual
Page 48 © April 2011
Chapter 6 TROUBLESHOOTING
6.1 Diagnostics Chart
• Power supply failure
• CPU failure
• Radio transmitting
RED flash
• Radio receiving data
• Weak radio signal (<-95dBm)
RED flash
• Serial Port Receiving
• Input buffer near full
• Serial port transmitting
• In transparent mode, always on.
• In controlled mode, a radio link
has been established.
The green OK LED on the front panel indicates correct operation of the unit. This LED
extinguishes on failure as described above. When the OK LED extinguishes shutdown state is
indicated. On processor failure, or on failure during startup diagnostics, the unit shuts down, and
remains in shutdown until the fault is rectified.
6.2 Test Functions
6.2.1 Radio Testing - AT&Tx
To aid in the checking and setup of the 805U unit, diagnostic functions are provided using the
standard Hayes AT commands. To perform the tests, you will need a terminal (PC + hyper-
terminal) set-up to match the module (same character type and serial speed). The table below
outlines the functions of the various tests:
AT&T Self Tests. Allows in-field diagnostics, and factory testing.
&T0 Transmit Bit Error Rate Test. Generates pseudo random data and sends out radio.
&T1 Receive Bit Error Rate Test. Receives data from &T0 module, and displays BER
statistics.
Kommentare zu diesen Handbüchern